P1R31FE30 - 003 : Varianti rispetto a P17.042.1

New setup parameters

Have been moved two existing parameters and included two new parameters in the setup page generic.

Parameters name	Unit of measure	Default	Range	Description
DxRot distance	mm	0.0	-9999.9 ÷ 99999.9	The X distance between the rotation axis C and the axis of rotation of the spindle when the axis C is located at 0 ° and the axis A is located at 90°.
DyRot distance	mm	20.0	-9999.9 ÷ 99999.9	The Y distance between the rotation axis C and the vertical axis of the blade when the axis C is located at 0 ° and the axis A is located at 90° (see the next image).
DzRot distance	mm	171.0	-9999.9 ÷ 99999.9	The Z distance between the tilt axis A and the axis of rotation of the spindle (see the next image).
DyAC distance	mm	119.0	-9999.9 ÷ 99999.9	The distance between the C axis and the A axis (see the next image).

There is a new setup page for the A axis:

Parameters name	Unit of measure	Default	Range	Description
Resolution	-	1/1	-	The resolution parameters to convert pulse to degrees: measure in °/10 over pulse.
Tolerance	°	0	0.0 ÷ 99999.9	The tolerance to check if the tilt position of A is to the right displacement.
Min A angle	rad	0	0.0 ÷ 9.99999	It is the minimun angle for axis A. If the A position is less than this angle, the cut will not be done.

There is a new feature allow on each manual page.

When you touch on the next button, it will toggle on one of the next picture. The meaning is the next:

	By the Z joystick activation, the machine move only the Z axis. So it will be a vertical displacement.
	By the Z joystick activation, the machine move the three XYZ axis in according of the A and C positions. So it will be a cut direction displacement.

There is a new work allow from the execution menu page. It is “Rectangle”:

There are the next work parameters:

Parameters name/picture	Unit of measure	Range	Description
	mm	0 ÷ 99999.9	W and H are the rectangle dimensions. These are the dimensions on the upper surface of the slab. The software processes the cut position in according to the saw thickness and tilting.
	-	-	For each edge of the rectangle you have to set the angle orientation. Touch on the icon, press the button to select the right icon and then press . As you can see from the icons, the tilting can be towards the inside or towards the outside of the rectangle.
	-	-
A	°	10.0 ÷ 90.0	The operator has to insert the tilting angle for each edges, even for vertical cut (90°).
	-	-	The operator can enable or disable each edges of the rectangle. He has to just touch the
	-	-
	mm	0 ÷ 99999.9	The operator has to insert the slab thickness.
	mm	-99999.9 ÷ 99999.9	It is possible to apply a correction of the start quote of the cut.
	mm	-99999.9 ÷ 99999.9	It is possible to apply a correction of the end quote of the cut.